Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Verify there is NO water in the fuel.NOTE: If other contaminants are noticed in the fuel, a fuel system flush may be necessary.
Refer to Water-in-Fuel Draining
- If there is water in the fuel
Drain off the water completely.
- If there is NO water in the fuel
- If there is water in the fuel
- Ignition ON.
- Verify the WATER IN FUEL - CONTACT SERVICE message is not displayed.
- If the WATER IN FUEL - CONTACT SERVICE message is displayed
Refer to Circuit/System testing.
- If the WATER IN FUEL - CONTACT SERVICE message is not displayed
- If the WATER IN FUEL - CONTACT SERVICE message is displayed
- All OK