LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Controls And Fuel - 2.0L (LUZ) Diesel - DTC P2122 To DTC P2689 And Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P2428: Exhaust Gas High Temperature >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Ignition On
  2. Verify no other DTCs are set.
    • If other DTCs are not set 
  3. Measure and record the resistance of the B131 Exhaust Gas Temperature sensor 1, 2 and 3. Compare the measurements to the Temperature Versus Resistance (EGT Sensors) , Temperature Versus Resistance (EGR Temperature Sensors) , Temperature Versus Resistance (Reductant Injector) , Temperature Versus Resistance (Reductant Tank Temperature Sensor) and Temperature Versus Resistance (Engine Coolant Temperature Sensor) table. The resistance values should be within the specified range indicated in the table.
    • If not within the specified range 

      Replace the appropriate B131 Exhaust Gas Temperature sensor

    • If within the specified range 
  4. Inspect for the following conditions:
    • If a condition is found 

      Repair as necessary

    • If no condition is found 
  5. Inspect the DOC/DPF and the SCR for any of the following conditions:
    • If a condition is found 

      Replace the DOC/DPF or the SCR.

    • If no condition is found 
  6. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  7. Verify the DTC does not set.
    • If the DTCs set 

      A condition with the system still exists.

    • If the DTC does not set 
  8. All OK.