LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission - AF40-6) >> Repair Instructions - On Vehicle >> Range Selector Lever Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Set the park brake and chock the wheels.
  2. Remove the front floor console. Refer to Front Floor Console Replacement .
  3. Remove the battery tray. Refer to Battery Tray Replacement .
  4. Verify that the transmission range selector lever is in park position.
  5. Verify that the transmission manual shift lever is in park position.
  6. Disconnect the transmission range selector lever cable end terminal (1) from the transmission manual shift lever pin (4).
    Fig 1: Transmission Range Selector Lever Cable End Terminal
    GM3221607Courtesy of GENERAL MOTORS COMPANY
  7. Press the locking tabs (2) inward (arrows) and clip out the transmission range selector lever cable from the bracket (3).
  8. Press the locking tabs inward in order to release the transmission range selector lever cable (1) from the cable bracket (3).
    Fig 2: Transmission Range Selector Lever Cable And Bracket
    GM2373479Courtesy of GENERAL MOTORS COMPANY
  9. Remove the cable end terminal from the shifter pin (2).
  10. Remove the transmission range selector lever cable grommet (2) from the bulkhead (1).
    Fig 3: Transmission Range Selector Lever Cable, Grommet & Bulkhead
    GM2834260Courtesy of GENERAL MOTORS COMPANY
  11. Remove the transmission range selector lever cable (3).
scientia non olet · About LEMON Manuals