Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Ignition ON, observe the scan tool Transmission Range Switch parameter while selecting each transmission range: park (P), reverse (R), neutral (N), drive (D).
Verify Each selected transmission range should correspond to the correct scan tool parameter displayed data.
- If the selected transmission range not correspond to the scan tool parameter displayed data
  Refer to Circuit/System Testing
- If the selected transmission range correspond to the scan tool parameter displayed data
Verify the engine start only in range position park (P) and neutral (N). The engine does not start in all other range positions.
- If the engine does not start at all or the engine starts in another range position than P and N
  Refer to Circuit/System Testing
- If the Engine start only in range position P and N
Verify there are no other DTCs are set.
- If any other DTC are set
  Refer to Diagnostic Trouble Code (DTC) List - Vehicle for further diagnosis.
- If none DTC are set
Operate the vehicle within the Conditions for Running the DTC. It may be helpful to operate the vehicle within the conditions identified from the Freeze Frame/Failure Records data.
Verify DTC P081A or P081B is not set.
- If the DTC sets
  Refer to Circuit/System Testing .
- If the DTC does not set
All OK.