LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 84 (Automatic Transmission - 6T40 (MH8 MHB) - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P182E or P1915: Internal Mode Switch >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify the range selector lever cable is adjusted properly. Refer to Range Selector Lever Cable Adjustment .
    • If cable adjustment is not OK 

      Repair as necessary.

    • If cable adjustment is OK 
  2. Ignition ON.
  3. Verify the scan tool TCM Internal Mode Switch A/B/C/P parameter matches the Transmission Internal Mode Switch Logic table for each transmission shift lever position.
    • If the parameter does not match 

      Refer to Circuit/System Testing.

    • If the parameter matches 
  4. Verify the scan tool engine control module Park/Neutral Position Switch parameter displays Park/Neutral with the gear shift lever in Park or Neutral and In Gear in Reverse or Drive.
    • If Park/Neutral or In Gear is not displayed 

      Refer to Circuit/System Testing.

    • If Park/Neutral and In Gear is displayed 
  5. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  6. Verify the DTC does not set.
    • If the DTC sets 

      Refer to Circuit/System Testing.

    • If the DTC does not set 
  7. All OK.
scientia non olet · About LEMON Manuals