Installation Procedure

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.

Fill the rear differential assembly. Refer to Differential Oil Replacement .

Fig 1: Rear Differential Assembly And Jack Stand

GM2770204

Courtesy of GENERAL MOTORS COMPANY

Using the transmission jack stand (2), lift the rear differential assembly (1) into position.
Install and hand tighten the 3 mounting bolts.

Fig 2: Rear Differential Support Mounting

GM2840985

Courtesy of GENERAL MOTORS COMPANY

Align the front rear differential mounting to the painted outline (1) on the body.

Fig 3: Rear Differential Support Mounting Bolts

GM2770194

Courtesy of GENERAL MOTORS COMPANY

CAUTION:

Refer to Fastener Caution .

Install the 2 rear mounting bolts (1) and tighten to 108 N.m (80 lb ft).

Fig 4: Rear Differential Mounting Bolt

GM2770164

Courtesy of GENERAL MOTORS COMPANY

Install the front mounting bolt (1) and tighten to 100 N.m (74 lb ft).

Fig 5: Jack Stand And Rear Differential

GM2769939

Courtesy of GENERAL MOTORS COMPANY

Remove the transmission jack stand (2) from the rear differential assembly (1).

Fig 6: Wiring Harness And Retainers

GM2769927

Courtesy of GENERAL MOTORS COMPANY

Reconnect the electrical harness connector (3).
Install the propeller shaft to the rear differential assembly. Refer to Two-Piece Propeller Shaft Replacement .
Install the rear wheel drive shafts to the rear differential. Refer to Rear Wheel Drive Shaft Replacement .
Refill the rear differential assembly. Refer to Differential Oil Replacement .
Remove the support and lower the vehicle.