Installation Procedure
WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
- Install the following components on the drivetrain and front suspension frame if removed:
- The rear transmission mount bracket-Refer to Transmission Mount Bracket Replacement - Rear (AWD)Transmission Mount Bracket Replacement - Rear (FWD) .
- The power brake booster pump, if equipped-Refer to Power Brake Booster Pump Replacement .
- The front bumper lower impact bar-Refer to Front Bumper Lower Impact Bar Replacement (Trax) .
- The lower control arms-Refer to Lower Control Arm Replacement .
- Install the frame (3) into the vehicle.
- Using a commercially available guide pin, have an assistant vertically insert and hold the pins through the front suspension frame and floor panel (1).
- Install the frame (3) rear fasteners (2) and tighten:
- First pass: 160 N.m (118 lb ft)
- Final pass: plus 30 to 45 degrees
- Install the frame front bolts and tighten:
- First pass: 100 N.m (74 lb ft)
- Final pass: plus 30 to 45 degrees
- Install the upper frame suspension retaining bolts (1) and tighten to 145 N.m (107 lb ft).
- Remove the wire retaining the power steering gear and stabilizer shaft to the vehicle.
- Install the steering gear retaining fasteners (1). Refer to Steering Gear Replacement (N40)Steering Gear Replacement (NJ1) .
- Connect the hydraulic power steering hoses to the front frame, if equipped.
- Connect the exhaust isolators (2) to the front suspension frame.
- Install the rear transmission mount bracket to rear mount through bolt (1). Refer to Transmission Rear Mount Replacement (AWD)Transmission Rear Mount Replacement (FWD) .
- Connect the power brake booster pump hose and connector, if equipped.
- Connect the lower ball joints to the steering knuckles. Refer to Lower Control Arm Replacement .
- Connect the stabilizer shaft to the drivetrain and front suspension frame. Refer to Stabilizer Shaft Replacement .
- Install the front compartment front center insulator, if equipped. Refer to Front Compartment Front Center Insulator Replacement .
- Install the underbody front air deflector. Refer to .
- Install the skid plate to the front frame, if equipped. Refer to Drivetrain and Front Suspension Frame Transmission Protector Replacement .
- Install the front tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
- Lower the vehicle.
- Remove the support of the radiator and condenser.
CAUTION:
Refer to Fastener Caution .