Installation Procedure
WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
- Install the crankshaft balancer carefully by pressing into position.
- Measure the distance (a) between the crankshaft balancer (2) and the mark on the engine front cover (1). The distance (a) should be 5.5 mm (0.21654 in).
- Install a NEW crankshaft balancer bolt.
- Tighten the crankshaft balancer bolt (4) to 150 N.m (111 lb ft) while holding the crankshaft balancer (3) with EN-49979 crankshaft shock mount retainer (1) and suitable tool (2). Use J-45059-A wrench.
- Tighten the crankshaft balancer bolt to an additional 45 - 60 degrees.
- Install the drive belt. Refer to Drive Belt Replacement .
- Install front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement (Chevrolet)Front Wheelhouse Liner Replacement (Buick) .
- Lower the vehicle.
- Check and correct engine oil level.
NOTE:
The crankshaft balancer flange must fit to the hexagon of the oil pump rotor (2) and to the two-flats of the crankshaft (1). The TDC markings on crankshaft balancer and engine front cover must match.
NOTE:
Never re-use the crankshaft balancer bolt.
CAUTION:
Refer to Fastener Caution .
CAUTION:
Refer to Torque-to-Yield Fastener Caution .