Drive Belt Removal

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools

EN-955 Locking Pins
EN-48488 Holding Wrench

For equivalent regional tools, refer to Special Tools .

Fig 1: Locking Pin And Wrench

Courtesy of GENERAL MOTORS COMPANY

Install EN-48488 wrench (1) to the drive belt tensioner.

NOTE:

The drive belt tensioner must always be in a pre-tensioned state.

Move the drive belt tensioner clockwise until the drive belt tensioner can be fixed with the EN-955-20 locking pin (2).
Remove the drive belt.