Drive Belt Installation

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools

EN-955 Locking Pins
EN-48488 Holding Wrench

For equivalent regional tools, refer to Special Tools .

NOTE:

Ensure that the drive belt tensioner is held with EN-955-2 locking pin.

Install the drive belt.

Fig 1: Locking Pin And Wrench

Courtesy of GENERAL MOTORS COMPANY

Move the drive belt tensioner clockwise until EN-955-20 locking pin (2) can be removed. Use EN-48488 wrench (1).
Remove EN-955-20 locking pin (2) from the drive belt tensioner while holding with EN-48488 wrench (1).
Release tension from drive belt tensioner and remove EN-48488 wrench (1).