LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 47 (Drum Brake System) >> Repair Instructions >> Rear Brake Backing Plate Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. If removed, install the park brake cable to the rear brake backing plate.
  2. Ensure the park brake cable locking tab is fully engaged in the rear brake backing plate.
    3. Fig 1: Park Brake Cable Connector & Backing Plate
    GM2507697Courtesy of GENERAL MOTORS COMPANY
  3. Insert the front park brake cable into the park brake cable connector (1).
  4. Install the rear brake backing plate (2).
  5. Install the rear wheel bearing and hub assembly. Refer to Rear Wheel Bearing and Hub Replacement (With Drum Brakes) .
  6. Install the rear wheel speed sensor, if equipped. Refer to Rear Wheel Speed Sensor Replacement .
  7. Install the rear brake cylinder. Refer to Rear Brake Cylinder Replacement .
  8. Install the brake shoes. Refer to Brake Shoe Replacement .
  9. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
scientia non olet · About LEMON Manuals