LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 44 (Power Steering System) >> Repair Instructions >> Power Steering Fluid Cooler Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove as much power steering fluid from the power steering fluid reservoir as possible.
  2. Front Bumper Fascia Replacement (Trax)Front Bumper Fascia Replacement (Encore) - Remove
    3. Fig 1: Power Steering Gear Outlet Hose And Clamp
    GM2812352Courtesy of GENERAL MOTORS COMPANY
  3. Power Steering Gear Outlet Hose Clamp to Power Steering Fluid Cooler - Loosen
  4. Power Steering Gear Outlet Hose to Power Steering Fluid Cooler - Separate
  5. Remove the plastic push pin (3) from the power steering fluid cooler bracket.
    6. Fig 2: P/S Fluid Reservoir Inlet Pipe
    GM2810052Courtesy of GENERAL MOTORS COMPANY
  6. Power Steering Fluid Reservoir Inlet Pipe Clamp to Power Steering Fluid Cooler - Loosen
  7. Power Steering Fluid Reservoir Inlet Pipe to Power Steering Fluid Cooler - Separate
    8. Fig 3: Power Steering Fluid Cooler
    GM2812359Courtesy of GENERAL MOTORS COMPANY
  8. Power Steering Fluid Cooler Nut - Remove
  9. Remove the power steering fluid cooler (2) from the vehicle.
scientia non olet · About LEMON Manuals