LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Automatic Transmission - 6T40 (MH8 MHB) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Range Selector Lever Cable Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the transmission range selector lever cable to the vehicle.
    2. Fig 1: Gear Shift Cable Grommet & Fasteners
    GM2526950Courtesy of GENERAL MOTORS COMPANY
  2. Install the transmission range selector lever cable grommet to the cowl panel.
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the grommet fasteners (2) and tighten to 9 N.m (80 lb in).
    4. Fig 2: Cable Terminal And Cable Retainer
    GM2759113Courtesy of GENERAL MOTORS COMPANY
  4. Install the transmission range selector lever cable to the transmission control lever base. Insure the cable retainer (1) is fully secured to the transmission control lever base.
  5. Connect the transmission range selector lever cable terminal (2) to the shift lever pin.
  6. Install the front floor console stowage tray. Refer to Front Floor Console Stowage Tray Replacement (Buick)Front Floor Console Stowage Tray Replacement (Chevrolet) .
    7. Fig 3: Automatic Transmission Range Selector Lever Cable Terminal & Shift Lever Pin
    GM2492632Courtesy of GENERAL MOTORS COMPANY
  7. Install the transmission range selector lever cable (2) to the cable bracket.
  8. Connect the transmission range selector lever cable terminal (1) to the transmission manual shift lever pin.
  9. Adjust the automatic transmission range selector lever cable. Refer to Range Selector Lever Cable Adjustment .
scientia non olet · About LEMON Manuals