Installation Procedure
WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
- Install the 3 input speed sensor seals (1).
- Install the input speed sensor (3).
- Verify that the retaining tabs are locked completely.
- Install the input speed sensor bolt (2) M6 x 23 and tighten to 9 N.m (80 lb in).
- Install the control valve body. Refer to Control Valve Body Replacement .
- Perform the transmission adaptive values learn procedure. Refer to Transmission Adaptive Values Learn .
CAUTION:
Refer to Fastener Caution .