Front Seat Belt Anchor Plate Tensioner Cover Replacement
WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| Preliminary Procedure If equipped with manual seat without vertical adjuster, the seat cushion outer finish panel must be removed. Refer to Driver or Passenger Seat Cushion Outer Finish Panel Replacement (Manual) Driver or Passenger Seat Cushion Outer Finish Panel Replacement (Power) . |
|
| 1 | Front Seat Belt Anchor Plate Tensioner Cover Fastener
CAUTION:
Refer to Fastener Caution . Tighten 5 N.m (44 lb in) |
| 2 | Front Seat Belt Anchor Plate Tensioner Cover Procedure Remove the tensioner cover by applying light pressure to the front of the cover, push the cover rearward to remove it from the seat frame.
NOTE:
If equipped with power or manual seat vertical adjuster, position the seat for access to the anchor plate tension cover and fastener. |