Circuit/System Verification

NOTE: The Brake Pedal Position sensor scan tool data is located in the ECM automatic transmission data list.

Ignition ON.
Verify DTC P0641, P0651, P0697 or P06A3 is not set.
- If any of the DTCs are set
  Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- If none of the DTCs are set
Transmission in Park and service brake pedal released.
Verify the scan tool Brake Pedal Position Sensor parameter is greater than 0.25 V.
- If 0.25 V or less
  Refer to Circuit/System Testing .
- If greater than 0.25 V
Verify the scan tool Brake Pedal Position Sensor parameter voltage changes as the brake pedal is applied and is less than 4.75 V when the brake pedal is fully applied.
- If the voltage does not change or is 4.74 V or greater
  Refer to Circuit/System Testing .
- If the voltage changes and is less than 4.75 V
Verify the scan tool Brake Pedal Position Sensor Learned Release Position parameter is within 0.1 V of the Brake Pedal Position Sensor parameter when the brake pedal is fully released.
- If difference is greater than 0.1 V
  Perform the Brake Pedal Position Sensor Learn .
- If difference is 0.1 V or less
Verify the Brake Pedal Position Sensor parameter transitions smoothly without any spikes or dropouts when slowly applying and releasing the brake pedal.
- If parameter does not transition smoothly or has spikes or dropouts
  Refer to Circuit/System Testing .
- If parameter transitions smoothly and there are no spikes or dropouts
Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
  Refer to Circuit/System Testing .
- If the DTC does not set
All OK.