LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling System >> Repair Instructions >> Engine Oil Cooler Outlet Hose Replacement (1.4L LUV, 1.8L LUW and LWE) >> Installation Procedure

Installation Procedure

  1. Install the oil cooler outlet hose to the oil cooler outlet pipe.
  2. Install the oil cooler outlet hose clamp.
  3. Install the oil cooler outlet pipe (2) in compound with the oil cooler outlet hose to the oil cooler.
    Fig 1: Oil Cooler Outlet Pipe
    GM2371625Courtesy of GENERAL MOTORS COMPANY
  4. Install the oil cooler outlet pipe bolt (1) to the engine block and tighten to 10 N.m (89 lb in).
  5. Install the warm up three way catalytic converter. Refer to Warm Up Three-Way Catalytic Converter Replacement
  6. Install the oil cooler outlet hose (3) to the thermostat housing (1).
    Fig 2: Thermostat Housing And Oil Cooler Outlet Hose
    GM2371623Courtesy of GENERAL MOTORS COMPANY
  7. Install the oil cooler outlet hose clamp (2).
  8. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement
  9. Install the turbocharger oil feed pipe and the exhaust manifold heat shield. Refer to Turbocharger Oil Feed Pipe Replacement
  10. Connect battery negative cable. Refer to Battery Negative Cable Disconnection and Connection
  11. Fill engine coolant. Refer to Cooling System Draining and Filling (GE-47716 Fill)  and Cooling System Draining and Filling (Static Fill) 
scientia non olet · About LEMON Manuals