LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling System >> Repair Instructions >> Engine Coolant Fan Replacement >> Installation Procedure

Installation Procedure

  1. Install the engine coolant fan.
    Fig 1: Identifying Engine Coolant Fan Resistor
    GM1936663Courtesy of GENERAL MOTORS COMPANY
  2. Install the 3 engine coolant fan engine bolts (3) to the engine coolant fan and tighten.
    CAUTION: Refer to Fastener Caution
  3. Clip in the engine coolant fan resistor wiring harness (arrows) to the shroud.
  4. Install the engine coolant fan resistor (1) by clipping the retainer clip (2).
  5. Install the engine coolant fan shroud (1).
    Fig 2: Identifying Engine Coolant Fan Shroud
    GM2191512Courtesy of GENERAL MOTORS COMPANY
    1. Lower the right hand side of the engine coolant fan shroud (1) behind the radiator.
    2. Slide the engine coolant fan shroud (1) toward the left side of the vehicle.
  6. Clip in the engine coolant fan shroud (1) to the four mounting points shown.
  7. Connect the engine coolant fan resistor wiring harness connector (1).
    Fig 3: Identifying Engine Coolant Fan Resistor Wiring Harness Connector
    GM2028322Courtesy of GENERAL MOTORS COMPANY
  8. Install the wiring harness (2) and clips.
  9. Install the front end upper tie bar. Refer to Front End Upper Tie Bar Replacement .
  10. Install the left and right side radiator air baffles.
  11. Install the radiator upper air seal.
  12. Connect battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About LEMON Manuals