Circuit/System Verification
- Ignition ON.
- Verify the scan tool parameters listed below do not display Malfunction while commanding the Engine Coolant Thermostat Heater to increase 100% and then decrease to 0%.
- Engine Coolant Thermostat Heater Control Circuit Low Voltage Test Status
- Engine Coolant Thermostat Heater Control Circuit Open Test Status
- Engine Coolant Thermostat Heater Control Circuit High Voltage Test Status
- If Malfunction is displayed
Refer to Circuit/System Testing .
- If Malfunction is displayed
- If Malfunction is not displayed
- Operate the vehicle within the conditions for running the DTC. You may also operate the vehicle within the conditions that you observed from the freeze frame/failure records data.
- Verify the DTC does not set.
- If any DTC sets
Refer to Circuit/System Testing .
- If the DTC does not set
- If any DTC sets
- All OK.