LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat Hardware, Seat Trim And Upholstery >> Repair Instructions >> Front Seat Cushion Cover and Pad Replacement >> Removal Procedure

Removal Procedure

WARNING: Refer to SIR Warning .
WARNING: Replace the passenger presence system as a complete assembly to prevent possible injury to the occupant. The bladder, the pressure sensor, the seat cushion and the control module are assembled and calibrated as a unit. Using only some of the components in the service kit will cause the passenger presence system to operate improperly.
WARNING: To avoid personal injuries, re-zero the passenger presence system whenever you remove or replace the seat cushion or trim. Failure to do so may cause the system to malfunction.
  1. Remove driver or passenger seat. Refer to Driver or Passenger Seat Removal and Installation .
  2. Remove front seat recliner handle. Refer to Front Seat Back Recliner Handle Replacement .
  3. Remove seat cushion inner trim panel. Refer to Front Seat Cushion Inner Trim Panel Replacement .
  4. Remove seat cushion outer trim panel. Refer to Front Seat Cushion Outer Trim Panel Replacement .
  5. Detach cushion cover from backrest below.
    Fig 1: Wiring Harness Plug
    GM2027608Courtesy of GENERAL MOTORS COMPANY
  6. Disconnect wiring harness plug (1), if equipped.
  7. Release the seat wiring harness as required from the seat bottom.
  8. Remove front seat backrest 4 screw (2).
  9. Remove backrest.
  10. Detach cushion cover (1) from seat frame (3) all the way round.
    Fig 2: Cushion Cover, Seat Frame And Pad
    GM2027611Courtesy of GENERAL MOTORS COMPANY
  11. Remove cushion cover (1) with pad (2) from frame (3).
  12. Remove cushion cover (1) from pad (2).
scientia non olet · About LEMON Manuals