LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat Hardware, Seat Trim And Upholstery >> Repair Instructions >> Front Seat Cushion Cover and Pad Replacement >> Installation Procedure

Installation Procedure

  1. Install cushion cover (1) to pad (2).
    Fig 1: Cushion Cover, Seat Frame And Pad
    GM2027611Courtesy of GENERAL MOTORS COMPANY
  2. Install cushion cover (1) with pad (2) to frame (3).
  3. Attach cushion cover (1) from seat frame (3) all the way round.
  4. Install backrest.
    Fig 2: Wiring Harness Plug
    GM2027608Courtesy of GENERAL MOTORS COMPANY
  5. Install 4 screws (2) and tighten to 35 N.m (26 lb ft).
    CAUTION: Refer to Fastener Caution .
  6. Connect the wiring harness plug (1), if equipped.
  7. Install the seat wiring harness as required to the seat bottom.
  8. Attach cushion cover to backrest below.
  9. Install seat cushion outer trim panel. Refer to Front Seat Cushion Outer Trim Panel Replacement .
  10. Install seat cushion inner trim panel. Refer to Front Seat Cushion Inner Trim Panel Replacement .
  11. Install front seat recliner handle. Refer to Front Seat Back Recliner Handle Replacement .
  12. Install driver or passenger seat. Refer to Driver or Passenger Seat Removal and Installation .
  13. After working on the passenger seat, program or re-zero the inflatable restraint passenger presence system after repairs or replacement. Refer to Control Module References .
scientia non olet · About LEMON Manuals