LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2014 >> Spark LT, Standard Trans >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Seats >> Seat Heating System And Seat Cooling System >> Repair Instructions >> Driver or Passenger Seat Cushion Heater Replacement

Driver or Passenger Seat Cushion Heater Replacement

Fig 1: Driver or Passenger Seat Cushion Heater
GM2833019Courtesy of GENERAL MOTORS COMPANY
Driver or Passenger Seat Cushion Heater Replacement

Callout Component Name
WARNING:

Refer to SIR Warning .

Preliminary Procedures

  1. Remove the driver or passenger seat. Refer to Driver or Passenger Seat Removal and Installation .
  2. Remove the front seat cushion cover and pad. Refer to Front Seat Cushion Cover and Pad Replacement .
1 Front Seat Cushion Cover
Procedure 
Separate the seat cushion from the seat cushion pad by pulling the cover away from the pad.
2 Front Seat Cushion Heater
WARNING:

Replace the passenger presence system as a complete assembly to prevent possible injury to the occupant. All the components in the service kit are assembled and calibrated as a unit. Using only some of the components in the service kit will cause the passenger presence system to operate improperly.

3 Front Seat Cushion Pad
NOTE:

The seat belt presence sensor and heat mat, if equipped, are integral parts of the seat cushion pad.