Engine Front Cover and Accessory Drive Belt Tensioner - FWD

Fig 1: Engine Front Cover & Accessory Drive Belt Tensioner Components - FWD

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Engine Front Cover
2	Engine Front Cover Bolt (Qty: 11) CAUTION: Refer to Fastener Caution . Procedure Tighten the engine front cover bolts in sequence. Tighten 25 (18 lb ft)
3	Engine Front Cover Bolt (Qty: 2) CAUTION: This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component. Procedure Tighten the two NEW front cover bolts in the sequence shown. Tighten the bolts a first pass to 15 (11 lb ft). Tighten the bolts a final pass 130 degrees using EN 45059 meter. Special Tools EN 45059 Angle Meter For equivalent regional tools, refer to Special Tools .
4	Engine Front Cover Bolt (Qty: 1) Tighten 58 (43 lb ft)
5	Engine Front Cover Bolt (Qty: 1) Tighten 25 (18 lb ft)
6	Engine Front Cover Bolt (Qty: 2) Tighten 10 (89 lb in)
7	Engine Front Cover Bolt (Qty: 2) Tighten 10 (89 lb in)
8	Engine Front Cover Bolt (Qty: 1) CAUTION: This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component. Procedure Tighten the NEW front cover bolt in the sequence shown. Tighten the bolt a first pass to 15 (11 lb ft). Tighten the bolt a final pass 130 degrees using EN 45059 meter. Special Tools EN 45059 Angle Meter For equivalent regional tools, refer to Special Tools .
9	Accessory Drive Belt Tensioner
10	Accessory Drive Belt Tensioner Bolt Tighten 58 (43 lb ft)