LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2014 >> Camaro Z/28 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical - 3.6L - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Intake Manifold Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Intake Manifold Cover & Cap
    GM2667623Courtesy of GENERAL MOTORS COMPANY
  1. Remove the intake manifold cover (2). Refer to Intake Manifold Cover Replacement - Front .
    2. Fig 2: Intake Manifold Cover & Retainers
    GM2667617Courtesy of GENERAL MOTORS COMPANY
  2. Remove the rear intake manifold cover retainers (1).
  3. Remove the rear intake manifold cover (2).
    4. Fig 3: PCV Dirty Air Tube
    GM2667575Courtesy of GENERAL MOTORS COMPANY
  4. Remove the PCV dirty air tube (1) from the right camshaft cover.
  5. Remove the PCV dirty air tube (1) from the intake manifold.
    6. Fig 4: Fuel Pipe Shield
    GM3961985Courtesy of GENERAL MOTORS COMPANY
  6. Remove the fuel pipe shield (2) to intake manifold bolts (1).
  7. Remove the air outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
    8. Fig 5: Map Sensor Connector, Brake Booster Vacuum Hose, Throttle Body Electrical Connector & Purge Solenoid
    GM2667600Courtesy of GENERAL MOTORS COMPANY
  8. Disconnect the brake booster vacuum hose (2) from the intake manifold.
  9. Remove electrical connector and hose from the purge solenoid (4)
  10. Disconnect the throttle body electrical connector (3).
  11. Disconnect the map sensor connector (1).
    12. Fig 6: Intake Manifold, Bolts & Gasket
    GM2667626Courtesy of GENERAL MOTORS COMPANY
  12. Remove the intake manifold bolts (1).
  13. Remove the intake manifold (2) and gasket (3).
  14. If replacing the intake manifold, disassemble the intake manifold. Refer to Intake Manifold Disassemble .
scientia non olet · About LEMON Manuals