LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2014 >> Camaro Z/28 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical - 3.6L - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Engine Front Cover Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Assemble the engine front cover. Refer to Engine Front Cover Assemble .
    2. Fig 1: View Of Engine Front Cover
    GM1306469Courtesy of GENERAL MOTORS COMPANY
  2. Use the EN 46109  engine front cover installation guide pins in order to install the engine front cover. Refer to Engine Front Cover Installation .
  3. Install the camshaft position actuator solenoid valves to the front cover. Refer to Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 1 (Right Side) Intake , Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 1 (Right Side) Exhaust , Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 2 (Left Side) Intake , and Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 2 (Left Side) Exhaust .
  4. Install the camshaft position sensors. Refer to Camshaft Position Sensor Replacement - Bank 2 (Left Side) Exhaust , Camshaft Position Sensor Replacement - Bank 2 (Left Side) Intake , Camshaft Position Sensor Replacement - Bank 1 (Right Side) Exhaust , and Camshaft Position Sensor Replacement - Bank 1 (Right Side) Intake .
  5. Install the crankshaft balancer. Refer to Crankshaft Balancer Installation .
  6. Install the starter. Refer to Starter Replacement .
  7. Install the power steering pump.
  8. Install the power steering pump pulley.
  9. Install the power steering fluid reservoir. Refer to Power Steering Fluid Reservoir Replacement .
  10. Install the generator bracket with the generator and the belt tensioner. Refer to Generator Bracket Replacement (LFX) .
  11. Install the A/C compressor and power steering belt tensioner.
  12. Install the accessory drive belts.
  13. Install the water outlet.
  14. Install the purge vent hose to the water outlet.
  15. Fill the cooling system. Refer to Cooling System Draining and Filling (LFX, Static Fill) .
  16. Install the camshaft covers. Refer to Camshaft Cover Replacement - Left Side , and Camshaft Cover Replacement - Right Side .
  17. Install the intake manifold. Refer to Intake Manifold Replacement .
  18. Install the engine cover. Refer to Intake Manifold Cover Replacement - Rear .
  19. Fill the cooling system. Refer to Cooling System Draining and Filling (LFX, Static Fill) .
scientia non olet · About LEMON Manuals