LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2014 >> Camaro Z/28 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Controls And Fuel - 3.6L - Repair Instructions) >> Repair Instructions >> Ignition Coil Replacement - Bank 1 >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
WARNING:

Refer to Safety Glasses and Compressed Air Warning .

  1. Ignition OFF.
  2. Remove the rear intake manifold cover. Refer to Intake Manifold Cover Replacement - Rear .
  3. If replacing the number three cylinder coil, remove the evaporative emissions canister purge solenoid valve. Refer to Evaporative Emission Canister Purge Solenoid Valve Replacement .
    4. Fig 1: Identifying Ignition Coil To Camshaft Cover Retaining Bolts
    GM1949892Courtesy of GENERAL MOTORS COMPANY
  4. Disconnect the ignition coil harness connectors from the ignition coils.
  5. Remove the ignition coil to camshaft cover retaining bolts (1).
  6. Remove the ignition coils (2) from the vehicle.
scientia non olet · About LEMON Manuals