Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

WARNING:

Verify DTC P182E or P1915 was not set by reviewing the scan tool Freeze Frame/Failure Records.
- If DTC P182E or P1915 was set
  Refer to DTC P182E or P1915 .
- If DTC P182E or P1915 was not set
Ignition ON.
Verify the gear shift lever position matches the scan tool TCM Internal Mode Switch parameter while slowly moving the gear shift lever from Park through all ranges.
- If the specified values are not correct
  Refer to Range Selector Lever Cable Adjustment .
- If the specified values are correct
Shift lever in the M position.
Verify the scan tool Driver Shift Request parameter changes from Inactive to Upshift when the plus button is pressed, and from Inactive to Downshift when the minus button is pressed.
- If Inactive, Upshift, and Downshift are not displayed
  Refer to Circuit/System Testing .
- If Inactive, Upshift, and Downshift are displayed
Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
  Refer to Circuit/System Testing .
- If the DTC does not set
All OK.