LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2013 >> Sonic RS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Automatic Transmission - 6T30/6T40 - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Range Selector Lever Cable Adjustment

Range Selector Lever Cable Adjustment

WARNING: This page is about a different variant/trim than selected.
    NOTE:

    Adjust the automatic transmission range selector cable while the transmission and the gear selector are in the Park position only. Failure to do so may cause mis-adjustment.

  1. Set the park brake and chock the wheels.
  2. Verify the transmission range select lever is in the park position.
  3. Verify the transmission manual shift lever is in the park position.
    4. Fig 1: Range Selector Lever Cable
    GM2527095Courtesy of GENERAL MOTORS COMPANY
  4. Disconnect the range selector cable (2) from the range selector cable bracket.
  5. Disconnect the range selector cable end (1) from the range selector lever.
  6. Release the range select cable adjuster clip from the cable end (1).
  7. Connect the range selector cable (2) to the range selector cable bracket.
  8. Connect the range selector cable end (1) to the range selector lever.
    9. Fig 2: Cable Tube & Adjuster Clip
    GM2492897Courtesy of GENERAL MOTORS COMPANY
  9. Depress the adjuster clip (1) locking the adjuster clip completely.
  10. Ensure the cable tube (2) is secure.
  11. Check the transmission range select lever in all gear selections for proper operation.
scientia non olet · About LEMON Manuals