Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Position the transmission control in the vehicle.
- Install the 4 transmission control bolts (1) and tighten to 9 N.m (80 lb in).
- Connect the shift lever and selector lever cables to the shift and selector control adjusters (2).
- Install the shift lever and selector lever cable retainers (1) to the transmission control (3)
- Press down and lock both cable adjustment retainers (1), one for each cable, to adjust the shift lever and selector lever cable.
- Adjust the shift lever and selector level cables. Refer to Manual Transmission Shift Lever Cable Adjustment .
- Install the floor console. Refer to Front Floor Console Replacement .
- Verify the correct operation of the transmission control assembly.
CAUTION:
Refer to Fastener Caution .