LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2013 >> Sonic RS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Automatic Transmission - 6T30/6T40 - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Range Selector Lever Cable Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Transmission Range Selector Cable Bracket & Bolts
    GM2527104Courtesy of GENERAL MOTORS COMPANY
  1. Install the transmission range selector cable bracket (2).
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the transmission range selector cable bracket bolts (1) and tighten to 18 N.m (14 lb ft).
    3. Fig 2: Range Selector Lever Cable
    GM2527095Courtesy of GENERAL MOTORS COMPANY
  3. Connect the range selector cable (2) to the range selector cable bracket.
  4. Connect the range selector cable end (1) to the range selector lever.
  5. Check the range selector cable adjustment. Refer to Range Selector Lever Cable Adjustment .
scientia non olet · About LEMON Manuals