Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Engine running
Verify DTC P0325, P0327, P0328 or P06B6 is not set.
- If DTC P0325, P0327 or P0328 is set with P06B6
  Refer to Circuit/System Testing .
- If only DTC P06B6 is set
  Replace the K20 Engine Control Module.
- If none of the DTCs are set
Verify the affected B68 Knock Sensor is properly tightened. Refer to Fastener Tightening Specifications .
Verify the scan tool parameters below display NO while moving the related harnesses and connectors for the affected B68 Knock Sensor.
- Cylinder 1 Knock Detected
- Cylinder 2 Knock Detected
- Cylinder 3 Knock Detected
- Cylinder 4 Knock Detected
  - If NO is not displayed
    Refer to Circuit/System Testing .
  - If NO is displayed
Operate the vehicle within the conditions for running the DTC. You may also operate the vehicle within the conditions that you observed from the freeze frame/failure Records data.
- If any of the DTCs set
  Refer to Circuit/System Testing .
- If none of the DTCs set
All OK