Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Install a NEW engine front cover seal (2).
- Install the engine front cover (1).
- Install the engine front cover bolts (1) and tighten to 20 N.m (15 lb ft).
- Install the engine oil cooler outlet pipe bolt (1) and tighten to 8 N.m (71 lb in).
- Install the oil pan. Refer to Oil Pan Replacement .
- Install the crankshaft sprocket (1). Refer to Crankshaft Sprocket Replacement .
- Install the water pump bolts (1) and water pump pulley (2) and tighten to 20 N.m (15 lb ft).
- Install the generator. Refer to Generator Replacement (LUW) .
- Install the air conditioning compressor. Refer to Air Conditioning Compressor Replacement (LDE, LUW, LWE) .
- Install the timing belt tensioner. Refer to Timing Belt Tensioner Replacement .
- Install the radiator outlet hose (1) to the water pump. Refer to Radiator Outlet Hose Replacement (LDE LUW) .
- Fill the cooling system. Refer to Cooling System Draining and Filling .
- Connect the negative battery cable (1). Refer to Battery Negative Cable Disconnection and Connection .
CAUTION:
Refer to Fastener Caution .