LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2013 >> Sonic RS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Mechanical - 1.8L (LUW, LWE)) >> Repair Instructions - On Vehicle >> Drive Belt Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Drive Belt Routing
    GM2512912Courtesy of GENERAL MOTORS COMPANY
  1. Install the drive belt (1).
  2. Fig 2: Drive Belt Tensioner And Special Tool
    GM2189264Courtesy of GENERAL MOTORS COMPANY
  3. Release tension to the tensioner by rotating counterclockwise (1).
  4. NOTE:

    Allow tensioner to slide back slowly.

  5. Remove EN 6349  pin (2).
  6. Apply tension to the tensioner clockwise (1).
  7. Install the front wheelhouse liner Inner front extension. Refer to Front Wheelhouse Liner Inner Front Extension Replacement (Left SIde) , Front Wheelhouse Liner Inner Front Extension Replacement (Right SIde, LWE, LUW) .