Knee Bolster Replacement (Cadillac)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Knee Bolster (Cadillac)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the park brake release handle. Refer to Parking Brake Release Handle Assembly Replacement .
1	Left Outer Trim Cover TIP: Refer to Instrument Panel Outer Trim Cover Replacement (Except Cadillac) , Instrument Panel Outer Trim Cover Replacement (Cadillac) .
2	Knee Bolster Assembly Screw (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten 2 N.m (18 lb in)
3	Knee Bolster Assembly Procedure Disconnect the electrical connections, if applicable. If replacing the knee bolster assembly, transfer all necessary components.
4	Retainer Clip (Qty: 4)