LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Tahoe PPV >> Repair and Diagnosis >> External Pages >> Different car >> Section 918 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> On-Vehicle Repair Instructions >> Automatic Transmission Range Selector Lever Cable Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the cable to the vehicle.
    2. Fig 1: View Of Cable Grommet At Floor Panel
    GM858974Courtesy of GENERAL MOTORS CORP.
  2. Install the cable grommet to the floor panel.
    3. Fig 2: View Of Range Selector Cable
    GM1774421Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Avoid unnecessary twisting/bending of the range selector cable when installing the cable to the support.
  3. Install the range selector cable to the support.
  4. Ensure that the transmission manual shaft lever is in the mechanical park position.
    5. Fig 3: View Of Cable, Steering Column Ball Stud & Steering Column Bracket
    GM1774419Courtesy of GENERAL MOTORS CORP.
  5. Install the cable to the steering column bracket.
  6. Ensure the tangs fully seat (snap) into the steering column bracket.
  7. Install the cable end to the steering column ball stud.
    8. Fig 4: View Of Steering Cable Retainer On Steering Column
    GM1774414Courtesy of GENERAL MOTORS CORP.
  8. Install the retainer securing the cable to the steering column.
  9. Position the carpet and insulation around the driver's area.
  10. Install the drivers seat. Refer to Front Seat Replacement - Bucket .
  11. Install the instrument panel knee bolster. Refer to Knee Bolster Replacement (without RPO SLT) or Knee Bolster Replacement (with RPO SLT) .
  12. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    13. Fig 5: View Of Range Selector Cable End At Transmission Range Selector Lever Ball Stud
    GM738167Courtesy of GENERAL MOTORS CORP.
  13. Align and install the cable to the bracket.
  14. Install the range selector cable end (2) to the transmission range selector lever ball stud (1).
  15. Install the cable clip on the transfer case, if equipped.
    16. Fig 6: View Of Retainer Securing Cable To Bracket
    GM858985Courtesy of GENERAL MOTORS CORP.
  16. Install the retainer that secures the cable to the bracket.
    17. Fig 7: View Of Clips On Cable From Floor Panel Reinforcement
    GM858969Courtesy of GENERAL MOTORS CORP.
  17. Install the clips on the cable to the floor panel reinforcement.
  18. Lower the vehicle.
  19. Test the transmission for proper shift operation.
  20. If all of the gear positions cannot be achieved, adjust the cable. Refer to Range Selector Lever Cable Adjustment .
scientia non olet · About LEMON Manuals