Front Side Door Adjustment

Fig 1: Front Side Door

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Remove the front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement .
1	Front Side Door CAUTION: Refer to Fastener Caution . Procedure Loosen the front side door hinge bolt (Qty: 4) to adjust the front side door. Adjust the front side door in order to obtain an even gap between the front side door and the roof, the rear door, the rocker panel and the front fender and so that the front side door is flush with the roof, the rear door, the rocker panel and the front fender. Adjustment Front side door to roof (a) 6 mm ± 1 mm (0.24 in ± 0.04 in) Front side door to rear side door (b) 3.5 mm ± 0.75 mm (0.14 in ± 0.03 in) Front side door molding to rocker panel molding (c) 5 mm ± 1 mm (0.2 in ± 0.04 in) Front side door to front fender (d) 3.5 mm + 0.75 mm - 0.5 mm (0.14 in + 0.03 in - 0.02 in) Tighten 25 N.m (18 lb ft)

Callout

Component Name

Preliminary Procedures
Remove the front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement .

Front Side Door

CAUTION:

Procedure

Loosen the front side door hinge bolt (Qty: 4) to adjust the front side door.
Adjust the front side door in order to obtain an even gap between the front side door and the roof, the rear door, the rocker panel and the front fender and so that the front side door is flush with the roof, the rear door, the rocker panel and the front fender.

Adjustment

Front side door to roof
(a) 6 mm ± 1 mm (0.24 in ± 0.04 in)
Front side door to rear side door
(b) 3.5 mm ± 0.75 mm (0.14 in ± 0.03 in)
Front side door molding to rocker panel molding
(c) 5 mm ± 1 mm (0.2 in ± 0.04 in)
Front side door to front fender
(d) 3.5 mm + 0.75 mm - 0.5 mm (0.14 in + 0.03 in - 0.02 in)

Tighten
25 N.m (18 lb ft)