LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 217 (Engine Mechanical - 1.4L (LDD, LDU, LUH, Or LUJ) - Repair Instructions - Off Vehicle (1 Of 2)) >> Piston, Connecting Rod, and Bearing Removal

Piston, Connecting Rod, and Bearing Removal

WARNING: This page is about a different car, the 2011 Chevrolet Cruze. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Connecting Rod Bearing Caps And Bolts
    GM2190741Courtesy of GENERAL MOTORS CORP.
    NOTE: Mark the installation position of the connecting rod bearing caps. The connecting rod bearings and bearing caps must not be interchanged with other connecting rods.
  1. Remove the 4 connecting rod bearing cap bolts (1) of cylinder 2 and 3.
  2. Remove the 2 connecting rod bearing caps (2) and the 2 connecting rod bearings of cylinder 2 and 3.
  3. Rotate the crankshaft 180°.
    4. Fig 2: Connecting Rod Bearing Caps And Bolts
    GM2190742Courtesy of GENERAL MOTORS CORP.
  4. Remove the 4 connecting rod bearing cap bolts (1) of cylinder 1 and 4.
  5. Remove the 2 connecting rod bearing caps (2) and the 2 connecting rod bearings of cylinder 1 and 4.
    6. Fig 3: Connecting Rods, Upper Connecting Rod Bearings And Pistons
    GM2190743Courtesy of GENERAL MOTORS CORP.
  6. Remove the 4 pistons (1) and connecting rods (2) and the 4 upper connecting rod bearings (3) from the cylinder block.
scientia non olet · About LEMON Manuals