LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 217 (Engine Mechanical - 1.4L (LDD, LDU, LUH, Or LUJ) - Repair Instructions - Off Vehicle (1 Of 2)) >> Intake Manifold Assemble (1.4L LUH and LUJ)

Intake Manifold Assemble (1.4L LUH and LUJ)

WARNING: This page is about a different car, the 2011 Chevrolet Cruze. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Evaporative Emission Canister Purge Solenoid Valve And Manifold Absolute Pressure Sensors
    GM2191857Courtesy of GENERAL MOTORS CORP.
  1. Install the evaporative emission canister purge solenoid valve (3).
  2. Install the 2 manifold absolute pressure sensors (2).
  3. Install the 2 manifold absolute pressure sensor bolts (1) and tighten.
    4. Fig 2: Fuel Injection Fuel Rail Assembly And Intake Manifold Gasket
    GM2191856Courtesy of GENERAL MOTORS CORP.
  4. Install the fuel injection fuel rail assembly (3).
    5. CAUTION: Refer to Fastener Caution .
  5. Install the 2 fuel injection rail bolts (2) and tighten to 8 N.m (71 lb in).
  6. Install the fuel injection rail ground cable nut (1) and tighten.
  7. Install a NEW intake manifold gasket (4).
scientia non olet · About LEMON Manuals