LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 217 (Engine Mechanical - 1.4L (LDD, LDU, LUH, Or LUJ) - Repair Instructions - Off Vehicle (1 Of 2)) >> Draining Fluids and Oil Filter Removal

Draining Fluids and Oil Filter Removal

WARNING: This page is about a different car, the 2011 Chevrolet Cruze. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Engine Oil Filter Element, Cap And Seal Ring
    GM2190433Courtesy of GENERAL MOTORS CORP.
  1. Remove the engine oil filter cap (2) along with the engine oil filter cap seal ring (3) and the oil filter element (1).
  2. Remove the oil pan drain plug and allow the oil to drain out.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the oil pan drain plug and a NEW seal ring and tighten to 14 N.m (124 lb in).
  4. Install the engine oil filter cap along with a NEW engine oil filter cap seal ring and a NEW oil filter element.
  5. Tighten the engine oil filter cap to 25 N.m (18 lb ft).
    6. Fig 2: Water Pump Drain Plug And Seal Ring
    GM2190440Courtesy of GENERAL MOTORS CORP.
  6. Remove the water pump drain plug (1) and the water pump drain plug seal ring (2) and allow the remaining coolant to drain out.
  7. Install the water pump drain plug and a NEW seal ring and tighten to 15 N.m (11 lb ft).
scientia non olet · About LEMON Manuals