Camshaft Position Actuator Solenoid Valve Removal
WARNING: This page is about a different car, the 2011 Chevrolet Cruze. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the 4 camshaft position actuator solenoid valve bolts (1).
- Move the intake camshaft position actuator solenoid valve (1) carefully counter clockwise in the position shown.
- Move the exhaust camshaft position actuator solenoid valve (2) carefully clockwise in the position shown.
- Carefully remove the 2 camshaft position actuator solenoid valves (2) and the seal rings (1).
Fig 2: Intake Camshaft Position Actuator Solenoid Valve And Exhaust Camshaft Position Actuator Solenoid Valve
CAUTION:
The camshaft position actuator solenoid valves must be kept parallel to the engine front cover during removal and installation. The camshaft position actuator solenoid valves can be damaged if they become wedged or stuck during this process.