Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Clean sealing surface.
- Install a NEW engine front cover seal (1).
- Install the engine front cover (4).
- Install the 8 engine front cover bolts (2, 3) and tighten to 20 N.m (15 lb ft).
- Push the engine oil cooler outlet pipe (3) to the water pump (6).
- Install the engine oil cooler outlet pipe bolts (5) and tighten to 8 N.m (71 lb in).
- Push the engine oil cooler inlet pipe (1) into the water pump (6).
- Install the engine oil cooler inlet pipe bolt (4) and tighten to 8 N.m (71 lb in).
- Install the radiator outlet hose to the water pump. Refer to Radiator Outlet Hose Replacement (LUW) , Radiator Outlet Hose Replacement (LUJ) .
- Install the oil pan. Refer to Oil Pan Replacement .
- Install the timing belt rear cover. Refer to Timing Belt Rear Cover Replacement .
- Install the generator. Refer to Generator Replacement (LUJ) , Generator Replacement (LUW) .
- Install the air conditioning compressor. Refer to Air Conditioning Compressor Replacement (LUJ) , Air Conditioning Compressor Replacement (LUW) .
- Install the exhaust manifold. Refer to Exhaust Manifold Replacement (LUW) .
- Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
- Fill the cooling system. Refer to Cooling System Draining and Filling (GE-47716 Fill) , Cooling System Draining and Filling (Static Fill) .
- Close the hood.
CAUTION:
Refer to Fastener Caution .