LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 90 (Front Suspension System) >> Repair Instructions >> Stabilizer Shaft Replacement (FE1/FE3) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Move the stabilizer bar into position from the right side of the vehicle.
    2. Fig 1: View Of Stabilizer Bar
    GM851718Courtesy of GENERAL MOTORS CORP.
  2. Install the stabilizer bushings on the stabilizer bar with the cut line facing rearward.
    3. Fig 2: View Of Stabilizer Bar Mounting Clamp
    GM851715Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  3. Install the stabilizer bar clamps and bolts.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

  4. Connect the stabilizer links to the stabilizer shaft. Refer to Stabilizer Shaft Link Replacement .
  5. Install the steering gear. Refer to Steering Gear Replacement .
  6. Install the rear transaxle mount. Refer to Transmission Rear Mount Replacement for the Getrag 5 Speed transmission, or Transmission Rear Mount Replacement for the MU3 transmission, or Transmission Rear Mount Replacement for the 4T40-E/4T45-E transaxle.
  7. Install the front wheels. Refer to Tire and Wheel Removal and Installation .
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals