LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Engine Mechanical - 2.0L) >> Repair Instructions - On Vehicle >> Engine Support Fixture >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
  2. Place the engine support fixture legs (1) from the J 28467-B  across the engine compartment.
  3. Install the engine support fixture legs (1) from the J 28467-500  on the engine support fixture long bar (2).
    4. Fig 1: View Of Engine Support Fixture
    GM1906669Courtesy of GENERAL MOTORS CORP.
  4. Install the radiator shelf tube J-28467-2A (1) on top of the strut tower tube J-28467-3 (2) above the engine front (right back) lift hook bracket.
  5. Install the round tube of the front support assembly J-28467-4A (3) through the large hole in the radiator shelf tube J-28467-2A.
  6. Locate the J-28467-4A front support assembly to the upper tie bar.
  7. Install the J-28467-9 7/16 inch x 2.0 inch quick-release pin (4) through the top hole in the J-28467-4A front support assembly.
    8. Fig 2: View Of Engine Support Fixture & Cross Bracket
    GM1906694Courtesy of GENERAL MOTORS CORP.
  8. Install the J-28467-1A cross bracket assembly (1).
  9. Hand tighten the J-28467-1A cross bracket wing nuts (2).
    10. Fig 3: View Of Lift Hook Assembly
    GM682139Courtesy of GENERAL MOTORS CORP.
  10. Install the J-28467-7A bolt hook through the J-28467-6A bracket.
  11. Install the J-28467-34 lift hook wing nut and washer to the J-28467-7A lift hook.
  12. Repeat the previous 2 steps in order to assemble 2 lift hooks and brackets.
    13. Fig 4: Identifying Engine Support Fixture & Cross Bracket
    GM1906671Courtesy of GENERAL MOTORS CORP.
  13. Install one of the lift hook and bracket assemblies (1) to the engine support fixture long bar (2).
  14. Install the other lift hook and bracket assembly (3) to the J-28467-2A radiator shelf tube (4) above the engine front lift bracket.
    15. Fig 5: Inserting Lift Hook Through Engine Rear Lift Bracket
    GM1906870Courtesy of GENERAL MOTORS CORP.
  15. Install the lift hook J-28467-7A through the engine rear lift bracket (2).
    16. Fig 6: Inserting Lift Hook Through Engine Front Lift Bracket
    GM1906874Courtesy of GENERAL MOTORS CORP.
  16. Install the lift hook J-28467-7A (3) through the engine front lift bracket (4).
  17. Hand tighten the lift hook wing nuts J-28467-34 (5) in order to remove all slack from the engine support fixture assembly.
scientia non olet · About LEMON Manuals