LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Engine Mechanical - 2.0L) >> Repair Instructions - On Vehicle >> Engine Mount Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Engine Mount To Intermediate Bracket Bolts
    GM1546774Courtesy of GENERAL MOTORS CORP.
  1. Place the engine mount onto the midrail and hand start the nuts.
    2. CAUTION: Refer to Fastener Caution .
  2. Tighten the engine mount to midrail nuts (4) to 100 N.m (74 lb ft).
    3. NOTE: The engine mount to intermediate bracket bolts must be hand started. Do not pry the engine mount to align the holes.
  3. Hand start the engine mount to intermediate bracket bolts.
    4. NOTE: The engine mount bracket bolts must be torqued in a mandatory torque sequence as shown.
  4. Tighten the engine mount to intermediate bracket bolts to 65 N.m (48 lb ft).
  5. Remove the hydraulic floor jack.
  6. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
scientia non olet · About LEMON Manuals