LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Engine Mechanical - 2.0L) >> Repair Instructions - On Vehicle >> Crankshaft Balancer Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Crankshaft Balancer
    GM412138Courtesy of GENERAL MOTORS CORP.
  1. Install the crankshaft balancer.
  2. Install a NEW crankshaft balancer bolt.
    3. Fig 2: View Of Harmonic Balancer Holder J38122-A
    GM467429Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  3. Use J 38122-A  to prevent the crankshaft from rotating while tightening the crankshaft balancer bolt.

    Tighten the bolt to 100 N.m (74 lb ft) plus 75 degrees.

  4. Install the engine drive belt. Refer to Drive Belt Replacement .
  5. Install the right engine splash shield. Refer to Engine Splash Shield Replacement - Right Side .
scientia non olet · About LEMON Manuals