LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 84 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Hood Primary and Secondary Latch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Hood Release Cable
    GM863872Courtesy of GENERAL MOTORS CORP.
  1. Install the hood latch release cable to the hood latch.
  2. Position the hood latch to the alignment marks on the support bracket.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the hood latch bolts.
  4. Tighten the latch bolts with the latch in the full up position.
  5. Slowly close the hood and press down until the hood is flush with the fenders.
  6. Raise the hood.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  7. Adjust the hood, if required. Refer to Hood Adjustment .
  8. Close the hood.
scientia non olet · About LEMON Manuals