LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 84 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Hood Hinge Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Hood Hinge To Hood Bolt
    GM867790Courtesy of GENERAL MOTORS CORP.
    WARNING: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.
  1. Open the hood.
  2. Place a suitable support between the hood and the air inlet grille panel.
  3. Using a grease pencil, mark the position of the hood hinge.
  4. Remove the front fender. Refer to Front Fender Replacement .
  5. Remove the hinge bolts and the hinge.
scientia non olet · About LEMON Manuals