LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 83 (Seat Belt System) >> Diagnostic Information and Procedures >> Seat Belt Indicator Circuit Malfunction - Driver >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON, observe the function of the seat belt indicator while commanding the I/P lamps ON and OFF with a scan tool. The seat belt indicator should turn ON and OFF when changing between the commanded states.
    • If the seat belt indicator is always OFF, replace the I/P cluster
  2. Ignition ON, with the driver seat occupied, buckle and unbuckle the driver seat belt, the seat belt indicator should go ON and OFF while buckling and unbuckling the occupied seat.
    • If the seat belt indicator lamp is always ON, refer to Circuit/System Testing , Seat Belt Indicator Always ON.
    • If the seat belt indicator lamp is always OFF, refer to Circuit/System Testing , Seat Belt Indicator Always OFF.
scientia non olet · About LEMON Manuals