LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 80 (Steering Wheel & Steering Column) >> Repair Instructions >> Steering Column Jacket Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the ignition lock cylinder case. Refer to Ignition Lock Cylinder Case Replacement .
  2. Remove the steering column and jacket assembly from the vehicle. Refer to Steering Column Replacement .
  3. Use a vise in order to hold the steering column. Clamp on the lower mounting bolt hole with the bolt hole sleeve in the horizontal position.
  4. Ensure the steering wheel alignment mark at the top of the steering column jacket shaft is in the 12 o'clock position.
    5. Fig 1: View Of Upper Jacket
    GM854910Courtesy of GENERAL MOTORS CORP.
  5. Remove the 3 steering column jacket bolts.
  6. Remove the steering column jacket from the steering column.
scientia non olet · About LEMON Manuals