LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Cruze Eco, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 79 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Air Conditioning Clutch Assembly Replacement (LNF) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the compressor. Refer to Air Conditioning Compressor Replacement .
    2. Fig 1: Identifying Compressor Clutch Plate Bolt
    GM872553Courtesy of GENERAL MOTORS CORP.
  2. Remove the three adjustable dowels from the J 37872  . See Special Tools .
  3. Install three 5/16 x 1 inch bolts in place of the dowels.
  4. Remove and discard the compressor clutch plate bolt.

    Use the J 37872  . See Special Tools .

    5. Fig 2: Identifying Compressor Clutch Plate
    GM872556Courtesy of GENERAL MOTORS CORP.
  5. Remove the compressor clutch plate from the compressor.
    6. Fig 3: View Of Compressor Pulley Snap Ring
    GM872558Courtesy of GENERAL MOTORS CORP.
  6. Remove the compressor pulley snap ring using the J 6083  . See Special Tools .
    7. Fig 4: Identifying Compressor Pulley
    GM872560Courtesy of GENERAL MOTORS CORP.
  7. Remove the compressor pulley from the compressor.
    8. Fig 5: Identifying Compressor Clutch Coil And Snap Ring
    GM872563Courtesy of GENERAL MOTORS CORP.
  8. Remove the compressor clutch coil snap ring using the J 6083  . See Special Tools .
    9. Fig 6: Identifying Compressor Clutch Coil To Compressor
    GM872561Courtesy of GENERAL MOTORS CORP.
  9. Remove the compressor clutch coil from the compressor.
scientia non olet · About LEMON Manuals